What Is This Tool?
This tool helps users convert values from IDE (UDMA mode 4), a high-speed Parallel ATA transfer mode, to IDE (UDMA-33), a legacy Parallel ATA data-transfer mode. It supports comparison and reporting for data transfer rates between these two legacy PATA standards.
How to Use This Tool?
-
Enter the value in IDE (UDMA mode 4) units that you want to convert
-
Select IDE (UDMA-33) as the target unit
-
Click the convert button to see the equivalent value
-
Use the results to assist in benchmarking, configuration, or reporting tasks
Key Features
-
Accurate conversion based on defined conversion rate between IDE (UDMA mode 4) and IDE (UDMA-33)
-
Supports benchmarking and configuration tasks for legacy PATA devices
-
Easy browser-based interface for quick data transfer comparisons
-
Useful for hardware repair, data recovery, and embedded systems maintenance
Examples
-
Converting 5 IDE (UDMA mode 4) equals 10 IDE (UDMA-33)
-
Converting 0.5 IDE (UDMA mode 4) equals 1 IDE (UDMA-33)
Common Use Cases
-
Benchmarking and reporting throughput of legacy PATA hard drives and optical drives
-
Configuring or troubleshooting DMA modes in BIOS or firmware for older PCs
-
Comparing legacy PATA performance when upgrading or replacing drives or controllers
-
Assisting in hardware repair and legacy computing maintenance tasks
Tips & Best Practices
-
Ensure you use appropriate cables (80-conductor IDE cables) for accurate performance
-
Verify BIOS or controller settings match the transfer mode for reliable measurements
-
Use this conversion for comparison purposes rather than predicting real-world speeds
-
Refer to hardware documentation when troubleshooting or configuring legacy hardware
Limitations
-
The specified speeds are theoretical; actual transfer rates can vary due to hardware and cable quality
-
These are legacy standards and may not be supported by modern devices or operating systems
-
Conversion results do not guarantee actual data transfer performance
Frequently Asked Questions
-
What devices typically use IDE (UDMA mode 4)?
-
IDE (UDMA mode 4) is used in older PATA hard drives and optical drives from the late 1990s and early 2000s that support ATA‑66.
-
Why would I convert IDE (UDMA mode 4) to IDE (UDMA-33)?
-
Users convert between these units to compare or report data transfer rates for benchmarking, configuring, or maintaining legacy PATA hardware.
-
Does this converter guarantee real-world transfer speeds?
-
No, the conversions reflect theoretical maximum throughputs and actual speeds may differ due to system factors.
Key Terminology
-
IDE (UDMA mode 4)
-
A Parallel ATA transfer mode using Ultra DMA protocol with a maximum theoretical throughput of about 66.7 MB/s requiring an 80-conductor IDE cable.
-
IDE (UDMA-33)
-
A Parallel ATA data-transfer mode also known as ATA/33 with a maximum theoretical burst rate of 33.3 MB/s, used for older PATA drives.
-
Conversion Rate
-
The factor used to convert between units; here, 1 IDE (UDMA mode 4) equals 2 IDE (UDMA-33).