What Is This Tool?
This converter helps you transform data transfer values from STS48 (signal), a high-capacity synchronous optical network transport rate, to IDE (UDMA mode 4), a legacy Parallel ATA data transfer mode. It enables comparison and analysis across different data transfer technologies.
How to Use This Tool?
-
Enter the numerical value in STS48 (signal) you want to convert
-
Select IDE (UDMA mode 4) as the target unit
-
Click the convert button to get the equivalent value
-
Review the results to compare data rates across technologies
-
Use provided examples for reference
Key Features
-
Convert high-speed STS48 optical signals to IDE (UDMA mode 4) units easily
-
Clear definitions and use cases for each unit type
-
Conversion based on accurate conversion rates provided
-
Suitable for telecommunications and legacy hardware analysis
-
Convenient browser-based unit comparison tool
Examples
-
1 STS48 (signal) equals approximately 4.71 IDE (UDMA mode 4)
-
2 STS48 (signal) is equivalent to about 9.43 IDE (UDMA mode 4)
Common Use Cases
-
Carrier backbone links for aggregating traffic between telecommunications offices
-
Connecting or benchmarking legacy IDE/ATA hardware in older PCs
-
Analyzing transfer rates between telecommunications and storage technologies
-
Maintaining and recovering data from older IDE devices
-
Diagnostic checks in embedded or legacy system firmware environments
Tips & Best Practices
-
Verify unit types before conversion to ensure correct comparison
-
Use conversion for benchmarking and compatibility analysis only
-
Remember the theoretical nature of conversion between vastly different technologies
-
Avoid assuming direct data transfer feasibility between STS48 and IDE without intermediate processing
-
Consult device documentation when configuring or troubleshooting legacy hardware
Limitations
-
STS48’s capacity is significantly higher than IDE (UDMA mode 4), limiting practical direct conversion
-
IDE (UDMA mode 4) is an outdated standard with maximum throughput around 66.7 MB/s
-
Conversion serves only as a reference for data rate comparison, not for direct hardware interfacing
-
Differences in technology generations make real-world data transfer between these units impractical
Frequently Asked Questions
-
What does STS48 (signal) represent?
-
STS48 (signal) is a high-capacity synchronous optical transport signal equivalent to OC-48, operating at approximately 2.48832 Gbit/s for multiplexed digital payloads.
-
What is IDE (UDMA mode 4)?
-
IDE (UDMA mode 4), also known as Ultra DMA/66, is a Parallel ATA transfer mode used in older PCs for data transfer at up to about 66.7 megabytes per second.
-
Can I directly transfer data from STS48 to IDE devices?
-
No, direct data transfer is impractical due to the large difference in speeds and technology; conversion is mainly for comparison and benchmarking.
Key Terminology
-
STS48 (signal)
-
A SONET signal level equal to OC-48, supporting synchronous data transport at around 2.48832 Gbit/s over optical fiber.
-
IDE (UDMA mode 4)
-
A Parallel ATA transfer mode allowing data movement at a maximum theoretical speed of approximately 66.7 MB/s using Ultra DMA protocol.
-
Ultra DMA
-
A protocol enabling efficient block data transfer between a storage drive and host system, used in parallel ATA interfaces.