What Is This Tool?
This converter facilitates transforming data transfer quantities measured in IDE (UDMA mode 4), a legacy disk interface mode, into H0, a protocol- or vendor-specific label used in certain logs or software. It helps bridge standard data rates with proprietary formats.
How to Use This Tool?
-
Enter the amount in IDE (UDMA mode 4) units.
-
Select IDE (UDMA mode 4) as the source unit and H0 as the target unit.
-
Click the convert button to get the corresponding H0 value using the conversion rate 1 IDE (UDMA mode 4) = 1375 H0.
-
Use the output to interpret or map legacy ATA data into vendor-specific notations.
Key Features
-
Converts IDE (UDMA mode 4) values to H0 units using the fixed conversion rate.
-
Handles legacy storage interface data transfer modes for maintenance and debugging.
-
Browser-based tool requiring no installation for quick conversion.
-
Supports interpreting proprietary or protocol-specific labels in data logs.
Examples
-
2 IDE (UDMA mode 4) equals 2750 H0.
-
0.5 IDE (UDMA mode 4) equals 687.5 H0.
Common Use Cases
-
Converting legacy PATA/IDE drive data transfer rates for embedded systems firmware troubleshooting.
-
Mapping ATA-66 mode metrics into protocol-specific fields in software logs.
-
Supporting benchmarking or data recovery workflows with older storage devices.
Tips & Best Practices
-
Confirm the local or vendor-specific definition of H0 before interpreting results.
-
Use this converter only within proprietary or legacy data format contexts.
-
Cross-check conversions when used for firmware debugging or hardware maintenance.
Limitations
-
H0 is not a standardized unit and varies by protocol or software implementation.
-
Conversions are context-dependent and should not be used for universal numeric analysis.
-
Incorrect usage outside intended contexts may cause misinterpretations.
Frequently Asked Questions
-
What is IDE (UDMA mode 4)?
-
IDE (UDMA mode 4), also called Ultra DMA/66 (ATA-4), is a Parallel ATA transfer mode using the Ultra DMA protocol to transfer data up to about 66.7 MB/s, requiring an 80-conductor IDE cable.
-
What does H0 represent?
-
H0 is a non-standard unit used as a protocol- or vendor-specific label in some logs or software fields without a universal definition.
-
Can I use this conversion for general data rate calculations?
-
No, this conversion should only be applied within proprietary or legacy data contexts as H0 lacks a standard quantitative meaning.
Key Terminology
-
IDE (UDMA mode 4)
-
A Parallel ATA transfer mode using Ultra DMA protocol at about 66.7 MB/s with an 80-conductor cable.
-
H0
-
A non-standard, protocol- or vendor-specific label used in certain software or logs lacking a universal quantitative definition.
-
Ultra DMA
-
A data transfer protocol used in some IDE modes to improve throughput by moving blocks of data efficiently.