What Is This Tool?
This converter enables you to translate data transfer rates from Virtual Tributary 6 (VT6), a SONET logical sub-channel, into IDE (UDMA mode 4), a Parallel ATA data transfer mode. It aids in comparing telecom channel capacities with PC storage transfer speeds.
How to Use This Tool?
-
Enter the amount in Virtual Tributary 6 (signal) units you want to convert.
-
Select Virtual Tributary 6 as the source unit and IDE (UDMA mode 4) as the target unit.
-
Click the convert button to get the equivalent value in IDE (UDMA mode 4).
-
Review conversion results based on the standardized conversion factor.
Key Features
-
Converts data transfer units between VT6 signals and IDE (UDMA mode 4) mode.
-
Based on standardized definitions used in SONET/SDH networks and legacy IDE storage.
-
Provides quick conversion with preset formulas and rates.
-
Browser-based tool requiring no installation.
Examples
-
5 Virtual Tributary 6 (signal) converts to approximately 0.05977 IDE (UDMA mode 4).
-
10 Virtual Tributary 6 (signal) equals about 0.11955 IDE (UDMA mode 4).
Common Use Cases
-
Mapping SONET mid-rate services to PC storage transfer equivalents.
-
Comparing bandwidth capacities between optical telecom channels and IDE devices.
-
Supporting legacy network and storage system integration and maintenance.
Tips & Best Practices
-
Use this tool for approximate data rate equivalences rather than precise protocol translations.
-
Consider hardware and signal quality factors when interpreting conversions.
-
Verify cable and device compatibility when working with IDE modes.
-
Apply conversions primarily for engineering comparisons and troubleshooting.
Limitations
-
Conversion focuses on data rate equivalences ignoring protocol differences.
-
Real throughput depends on device support and cable quality in IDE systems.
-
VT6 is a logical channel and may not reflect physical transmission constraints directly.
-
These conversions do not account for overhead or error correction impacts.
Frequently Asked Questions
-
What is Virtual Tributary 6 (VT6)?
-
VT6 is a logical sub-channel defined in the SONET standard used to carry and groom lower-rate client signals inside an STS-1 payload.
-
What does IDE (UDMA mode 4) refer to?
-
IDE (UDMA mode 4) is a Parallel ATA transfer mode also known as Ultra DMA/66, facilitating data transfer at about 66.7 MB/s using an 80-conductor IDE cable.
-
Why convert between VT6 signals and IDE modes?
-
Converting helps compare telecommunications SONET channel capacities with PC storage data transfer modes for integration, maintenance, or benchmarking purposes.
Key Terminology
-
Virtual Tributary 6 (VT6)
-
A SONET logical sub-channel used to multiplex lower-rate signals within an STS-1 frame.
-
IDE (UDMA mode 4)
-
A Parallel ATA transfer mode known as Ultra DMA/66 that moves data at up to about 66.7 MB/s using an 80-wire cable.
-
SONET
-
A standardized optical telecommunications transport protocol framework.