What Is This Tool?
This unit converter transforms data transfer rates measured in IDE (UDMA mode 1), a legacy Ultra DMA mode for Parallel ATA devices, into equivalent values expressed in SCSI (Ultra-2), a parallel Small Computer System Interface standard used widely in enterprise storage and high-performance environments.
How to Use This Tool?
-
Enter the data transfer value in IDE (UDMA mode 1) units
-
Select IDE (UDMA mode 1) as the source unit and SCSI (Ultra-2) as the target unit
-
Click convert to get the equivalent data transfer rate in SCSI (Ultra-2)
-
Use the result to compare performance or troubleshoot storage interface configurations
Key Features
-
Converts data rates from IDE (UDMA mode 1) to SCSI (Ultra-2)
-
Based on a defined conversion rate reflecting theoretical maximum transfer speeds
-
Supports benchmarking and comparison of legacy and modern storage interfaces
-
Browser-based and easy to use for quick diagnostics and analysis
-
Helps in understanding transfer rate differences relevant to storage system integration
Examples
-
2 IDE (UDMA mode 1) units convert to 0.625 SCSI (Ultra-2)
-
4 IDE (UDMA mode 1) units convert to 1.25 SCSI (Ultra-2)
Common Use Cases
-
Comparing transfer rates between older PATA devices and advanced parallel SCSI systems
-
Benchmarking legacy hard disk and optical drive throughput against Enterprise storage standards
-
Troubleshooting and selecting compatible transfer modes for vintage PCs and storage controllers
-
Supporting maintenance and integration of archival or legacy storage systems
-
Evaluating storage options in data centers and high-performance computing environments
Tips & Best Practices
-
Always verify the transfer mode settings on your hardware before conversion
-
Use this converter for theoretical maximum rates, not actual throughput measurements
-
Consult hardware documentation when troubleshooting transfer errors or incompatibilities
-
Consider device and system limitations when interpreting conversion results
-
Use conversions to aid system design and data migration planning
Limitations
-
Conversion reflects theoretical maximum speeds, not real-world performance
-
Does not account for protocol overhead or hardware-specific variations
-
Legacy IDE UDMA modes are significantly slower than modern SCSI Ultra-2 standards
-
Practical data transfer rates may vary due to device and system architecture differences
Frequently Asked Questions
-
What does IDE (UDMA mode 1) represent?
-
IDE (UDMA mode 1) is a transfer mode for Parallel ATA interfaces that provides a maximum data transfer rate of about 25 MB/s, mainly used in older PATA devices.
-
What is SCSI (Ultra-2)?
-
SCSI (Ultra-2) is a parallel SCSI standard using Low Voltage Differential signaling to deliver higher transfer speeds and longer cable lengths for enterprise and high-performance storage devices.
-
Why convert IDE (UDMA mode 1) to SCSI (Ultra-2)?
-
Conversion helps compare and benchmark legacy PATA devices with faster, more advanced SCSI systems, aiding system design, troubleshooting, and data migration.
Key Terminology
-
IDE (UDMA mode 1)
-
An Ultra DMA transfer mode for Parallel ATA interface allowing roughly 25 MB/s data transfer, used in older PATA devices.
-
SCSI (Ultra-2)
-
A parallel Small Computer System Interface standard employing Low Voltage Differential signaling for higher performance and longer cable lengths.
-
Conversion Rate
-
The fixed multiplier (0.3125) used to translate IDE (UDMA mode 1) units into equivalent SCSI (Ultra-2) units.