What Is This Tool?
This converter allows users to translate data transfer values from IDE (UDMA-33), a Parallel ATA transfer mode, into SCSI (Async), an asynchronous transfer mode of the SCSI protocol. It is designed to assist with benchmarking, troubleshooting, and configuring legacy hardware systems.
How to Use This Tool?
-
Enter the value in IDE (UDMA-33) units you wish to convert
-
Select IDE (UDMA-33) as the source unit and SCSI (Async) as the target unit
-
Click convert to see the equivalent value in SCSI (Async)
-
Use the results to compare throughput or assist with hardware configuration
Key Features
-
Converts between IDE (UDMA-33) and SCSI (Async) data transfer units
-
Facilitates comparison of different legacy storage interface performances
-
Supports troubleshooting and configuration tasks for older hardware
-
Browser-based, easy-to-use interface for quick unit conversions
Examples
-
1 IDE (UDMA-33) equals 22 SCSI (Async)
-
3 IDE (UDMA-33) equals 66 SCSI (Async)
Common Use Cases
-
Benchmarking throughput between legacy PATA and SCSI devices
-
Troubleshooting drive and controller transfer mode settings in older PCs
-
Configuring retrocomputing or embedded systems using legacy storage interfaces
-
Comparing performance for hardware upgrades or replacements of legacy drives
Tips & Best Practices
-
Ensure controller and cables support the desired IDE mode for accurate benchmarking
-
Use this conversion primarily for theoretical or relative performance comparisons
-
Account for device response times and bus arbitration when interpreting results
-
Combine converter output with practical testing to troubleshoot hardware issues
Limitations
-
Conversion compares theoretical throughput units that differ in transfer methods
-
IDE (UDMA-33) uses burst DMA, whereas SCSI (Async) relies on asynchronous handshaking
-
Real data transfer rates may vary based on device behavior and system conditions
Frequently Asked Questions
-
What does IDE (UDMA-33) represent in data transfer?
-
IDE (UDMA-33) is a Parallel ATA data transfer mode that uses direct memory access with a maximum theoretical burst rate of 33.3 MB/s.
-
How is SCSI (Async) different from IDE (UDMA-33)?
-
SCSI (Async) uses asynchronous data transfer via request/acknowledge handshakes, making its throughput dependent on device response and bus arbitration, unlike the burst DMA in IDE (UDMA-33).
-
Can this converter be used for real-time performance measurement?
-
No, this tool provides theoretical or relative throughput estimates since actual rates depend on hardware and protocol specifics.
Key Terminology
-
IDE (UDMA-33)
-
A Parallel ATA data transfer mode using direct memory access with a peak burst rate of 33.3 MB/s, common in older hard drives and optical drives.
-
SCSI (Async)
-
An asynchronous data transfer mode of the SCSI protocol where data exchange depends on request/acknowledge handshaking rather than a shared clock.
-
Burst Rate
-
The maximum rate at which data can be transferred in a quick succession during a data burst.