What Is This Tool?
This converter helps you translate data transfer rates from IDE (UDMA mode 2), a disk interface transfer mode, to modem (110), a legacy modem transmission speed, providing insight into the differences between storage and telecommunication data rates.
How to Use This Tool?
-
Enter the value in IDE (UDMA mode 2) units you wish to convert
-
Select modem (110) as the target unit
-
Click the convert button to get the data rate in modem (110) units
Key Features
-
Converts data rates from IDE (UDMA mode 2) to modem (110)
-
Provides a theoretical rate comparison between bytes per second and bits per second
-
Useful for understanding legacy and modern data transfer speed differences
-
Browser-based and easy to use
Examples
-
1 IDE (UDMA mode 2) equals 2,400,000 modem (110)
-
0.5 IDE (UDMA mode 2) equals 1,200,000 modem (110)
Common Use Cases
-
Configuring legacy PC BIOS or drive controllers for ATA/33 transfer modes
-
Comparing benchmark results involving UDMA mode 2 disk drives
-
Historical data communication research on teleprinter or teletype links
-
Testing vintage hardware or emulating old modem performance
-
Documenting legacy telemetry or serial communication rates
Tips & Best Practices
-
Use this conversion to gain perspective on data rate differences between old and newer technologies
-
Apply the tool when troubleshooting legacy hardware or firmware issues involving UDMA modes
-
Consider the differing data transfer methods to avoid misinterpreting speed comparisons
-
Remember the conversion is theoretical and reflects different transfer paradigms
Limitations
-
This conversion compares fundamentally different technologies and units
-
IDE rates are bulk data transfer in bytes per second; modem (110) reflects very low bit rate serial communication
-
It does not indicate practical interchangeability or actual performance equivalence
-
Differences in signaling and protocol mean the conversion is purely theoretical
Frequently Asked Questions
-
What does IDE (UDMA mode 2) represent?
-
IDE (UDMA mode 2) is an Ultra DMA transfer mode for PATA interfaces, also known as ATA/33, with a maximum theoretical transfer rate of about 33.3 megabytes per second.
-
What is modem (110) speed used for?
-
Modem (110) denotes a legacy modem transmission rate of about 110 bits per second, used in early dial-up and teletype communications.
-
Can I use this conversion for practical data transfer?
-
No, this conversion is theoretical and compares different types of data transfer; it is not meant for practical interchange or direct performance evaluation.
Key Terminology
-
IDE (UDMA mode 2)
-
An Ultra DMA transfer mode for Parallel ATA interfaces, providing about 33.3 megabytes per second transfer rate, known as ATA/33.
-
modem (110)
-
A legacy modem transmission speed of roughly 110 bits per second, used in early dial-up and teletype communications.
-
Data Transfer Rate
-
The speed at which data is transmitted from one device to another, measured here in bytes per second or bits per second.