What Is This Tool?
This converter allows you to convert data transfer rates from STM-64 (signal), a high-capacity optical network standard, to IDE (UDMA mode 2), a legacy data transfer mode used in older PC hardware. It helps compare and understand speeds across different technology eras.
How to Use This Tool?
-
Enter the value in STM-64 (signal) units you want to convert
-
Select IDE (UDMA mode 2) as the target unit
-
Click convert to see the equivalent transfer rate in IDE (UDMA mode 2)
-
Use the output for comparison, diagnostics, or legacy system analysis
Key Features
-
Converts between STM-64 (signal) and IDE (UDMA mode 2) data transfer units
-
Easy input of values for quick conversion results
-
Provides practical benchmarking comparisons between high-speed optical and legacy PC transfer rates
-
Browser-based and user-friendly interface
Examples
-
1 STM-64 (signal) equals approximately 37.7 IDE (UDMA mode 2) units
-
2 STM-64 (signal) converts to about 75.4 IDE (UDMA mode 2)
Common Use Cases
-
Benchmarking extremely high-speed fiber optic network rates against older PC hard drive speeds
-
Analyzing and comparing legacy PC BIOS or drive-controller configurations with modern network standards
-
Diagnosing PATA drive performance or firmware compatibility issues involving UDMA mode 2
-
Managing technology environments with both modern optical and legacy PATA storage equipment
Tips & Best Practices
-
Use this converter mainly for understanding or academic comparison rather than operational use
-
Keep in mind the differing units and technologies each measurement standard represents
-
Refer to legacy system manuals when interpreting IDE (UDMA mode 2) configurations
-
Use alongside professional diagnostic tools when troubleshooting hardware compatibility
Limitations
-
STM-64 measures fiber-optic network rates in gigabits per second, while IDE (UDMA mode 2) uses megabytes per second for PC interfaces, making direct use of conversions theoretical
-
Due to differences in data encoding and technology, actual throughput and performance vary greatly between units
-
IDE (UDMA mode 2) is obsolete in modern systems, so conversions are mainly of academic or legacy interest
Frequently Asked Questions
-
What does STM-64 (signal) represent?
-
STM-64 is the Synchronous Transport Module level-64 signal in the Synchronous Digital Hierarchy (SDH), used primarily for high-capacity core and long-haul fiber links with a line rate near 10 Gbit/s.
-
What is IDE (UDMA mode 2)?
-
IDE (UDMA mode 2) is an Ultra DMA transfer mode for Parallel ATA interfaces, commonly referred to as ATA/33, offering about 33.3 megabytes per second for data transfers in older PC hardware.
-
Why convert between these two units?
-
Converting STM-64 to IDE (UDMA mode 2) helps compare extremely fast optical network speeds with legacy PC drive data rates, useful for benchmarking, legacy system analysis, or compatibility checks.
Key Terminology
-
STM-64 (signal)
-
A high-speed optical network signal standard in SDH with about 10 Gbit/s line rate, used for long-haul fiber backbone systems.
-
IDE (UDMA mode 2)
-
A legacy PC data transfer mode also known as ATA/33, delivering up to 33.3 MB/s for Parallel ATA interfaces.
-
Synchronous Digital Hierarchy (SDH)
-
A standard technology for transmitting digital signals over fiber optic networks, with STM-64 being a high-level signal rate.