What Is This Tool?
This converter allows you to translate data transfer rates from the SCSI (LVD Ultra80) interface to the IDE (UDMA mode 2) standard. It helps in evaluating and comparing the data transfer capabilities of these two legacy storage technologies used in server and PC environments.
How to Use This Tool?
-
Enter the data transfer value measured in SCSI (LVD Ultra80).
-
Select SCSI (LVD Ultra80) as the source unit.
-
Select IDE (UDMA mode 2) as the target unit.
-
Click convert to see the equivalent data transfer rate in IDE (UDMA mode 2).
Key Features
-
Converts data transfer values between SCSI (LVD Ultra80) and IDE (UDMA mode 2).
-
Browser-based and easy to use without installation.
-
Provides quick insights into relative transfer speeds for legacy hardware.
-
Supports performance comparison and troubleshooting for legacy storage devices.
Examples
-
1 SCSI (LVD Ultra80) converts to approximately 2.42 IDE (UDMA mode 2).
-
5 SCSI (LVD Ultra80) converts to approximately 12.12 IDE (UDMA mode 2).
Common Use Cases
-
Comparing throughput of high-performance server disk arrays with legacy PC storage devices.
-
Assessing transfer speeds during IT infrastructure upgrades or migrations involving legacy systems.
-
Troubleshooting compatibility and performance issues on older PATA/IDE and SCSI storage interfaces.
Tips & Best Practices
-
Use the converter for estimating relative data transfer rates rather than exact performance metrics.
-
Consider device condition and system overhead when interpreting converted values.
-
Use alongside hardware documentation to troubleshoot compatibility between SCSI and IDE systems.
Limitations
-
Conversion rates represent theoretical maximum bandwidths and may not match real-world speeds.
-
Direct device interoperability between SCSI and IDE interfaces is limited and may require additional hardware.
-
This tool is intended for performance estimation, not for direct data transfer or device replacement.
Frequently Asked Questions
-
What is SCSI (LVD Ultra80)?
-
SCSI (LVD Ultra80) is a Low Voltage Differential version of the Ultra2 SCSI interface that delivers up to 80 MB/s on a wide, 16-bit bus using 40 MHz synchronous transfers with improved noise immunity.
-
What does IDE (UDMA mode 2) refer to?
-
IDE (UDMA mode 2), also known as ATA/33, is a transfer mode for Parallel ATA interfaces that provides a maximum theoretical data transfer rate of about 33.3 MB/s using specific signaling timing.
-
Why should I convert between these two units?
-
Converting between SCSI (LVD Ultra80) and IDE (UDMA mode 2) helps compare data transfer capabilities and troubleshoot legacy hardware operating with different interface standards.
Key Terminology
-
SCSI (LVD Ultra80)
-
A Low Voltage Differential variant of the Ultra2 SCSI interface with max bandwidth of 80 MB/s using a 16-bit wide bus and 40 MHz synchronous transfer.
-
IDE (UDMA mode 2)
-
An Ultra DMA transfer mode for Parallel ATA interfaces providing about 33.3 MB/s transfer speed, also known as ATA/33.