What Is This Tool?
This tool allows you to convert data transfer speeds from modem (110), an early low-rate transmission standard, to SCSI (LVD Ultra80), a high-speed storage interface. It is useful for comparing and understanding data rates across different generations of communication and storage hardware.
How to Use This Tool?
-
Enter the value in modem (110) units representing data transfer speed.
-
Choose modem (110) as the input unit and SCSI (LVD Ultra80) as the output unit.
-
Click the convert button to see the equivalent speed in SCSI (LVD Ultra80) units.
Key Features
-
Converts modem (110) bit rate values to SCSI (LVD Ultra80) throughput
-
Supports analysis of legacy and modern data transfer units
-
Helps bridge speed comparisons between vintage communication links and high-performance storage buses
-
Browser-based and easy to use without software installation
Examples
-
Converting 100 modem (110) units results in approximately 0.0000171875 SCSI (LVD Ultra80).
-
Converting 1,000,000 modem (110) units results in approximately 0.171875 SCSI (LVD Ultra80).
Common Use Cases
-
Evaluating legacy modem (110) communications in vintage computer and teleprinter systems.
-
Testing and comparing old serial link performance against modern storage interfaces.
-
Documenting historical or telemetry data rates specified using modem (110) bit rates.
-
Supporting protocol compatibility testing involving slow serial modems and fast SCSI devices.
-
Analyzing high-performance server disk arrays or RAID enclosures using SCSI (LVD Ultra80).
Tips & Best Practices
-
Use this converter primarily for historical comparison or academic research due to the large difference in speeds.
-
Consider unit differences since modem (110) is in bits per second and SCSI (LVD Ultra80) is based on bytes per second bandwidth.
-
Interpret results carefully because the conversion bridges very different technology generations and transfer methods.
-
Verify conversion values for legacy system emulation or protocol testing scenarios.
Limitations
-
The extremely low bit rate of modem (110) compared to the very high bandwidth of SCSI (LVD Ultra80) produces very small conversion results.
-
Differences in unit bases and technology eras can cause conceptual mismatches when analyzing conversions.
-
Conversion values may have limited use outside of historical and academic contexts.
Frequently Asked Questions
-
What does modem (110) represent in data transfer?
-
Modem (110) refers to a nominal legacy modem transmission speed of about 110 bits per second used in early dial-up communications and teletype systems.
-
What is SCSI (LVD Ultra80)?
-
SCSI (LVD Ultra80) is a high-speed Low Voltage Differential variant of the Ultra2 SCSI interface providing up to 80 megabytes per second over a 16-bit bus with improved signal quality.
-
Why convert from modem (110) to SCSI (LVD Ultra80)?
-
Conversion helps compare very slow legacy modem speeds to modern or legacy high-speed storage interfaces to understand relative transfer rates across hardware generations.
Key Terminology
-
modem (110)
-
A legacy modem transmission speed of approximately 110 bits per second used in early dial-up and teletype communications.
-
SCSI (LVD Ultra80)
-
A Low Voltage Differential version of Ultra2 SCSI interface offering up to 80 megabytes per second bandwidth over a 16-bit wide bus.
-
Data transfer rate
-
The speed at which data is transmitted over a communication link or bus, measured in bits or bytes per second.