What Is This Tool?
This tool helps convert data transfer rates from the modem (110), an early low-speed communication rate, to SCSI (LVD Ultra160), a high-speed storage interface bandwidth. It facilitates understanding and comparison between historical telecommunication speeds and modern storage device throughput.
How to Use This Tool?
-
Enter the value in modem (110) units representing bits per second
-
Select the target unit as SCSI (LVD Ultra160) representing megabytes per second bandwidth
-
Perform the conversion to get an equivalent data transfer rate expressed in SCSI (LVD Ultra160)
-
Use the results to compare historical data rates against modern storage interface speeds
Key Features
-
Converts data rates from modem (110) to SCSI (LVD Ultra160) units
-
Shows relationships between legacy modem speeds and modern storage interface bandwidths
-
Supports analysis for vintage computing and legacy communications
-
Assists system compatibility and migration planning involving disparate data transfer technologies
Examples
-
Converting 110 modem (110) yields approximately 9.453125e-6 SCSI (LVD Ultra160)
-
Converting 1000 modem (110) results in roughly 8.59375e-5 SCSI (LVD Ultra160)
Common Use Cases
-
Analyzing character-based teleprinter communications in vintage systems
-
Emulating legacy modem link performance for protocol testing
-
Specifying transfer rates for internal disk arrays and RAID controllers using SCSI
-
Comparing tape drive throughput on parallel SCSI interfaces
-
Planning system migrations involving legacy storage buses
Tips & Best Practices
-
Understand that modem (110) is a legacy low-speed rate and not directly interchangeable with SCSI bandwidth
-
Use conversions primarily to compare relative throughput rather than exact physical performance
-
Apply this tool in contexts like legacy communications analysis or storage engineering
-
Be aware of scale differences and interpret results accordingly
Limitations
-
Units represent vastly different technologies and speed scales, so conversions reflect relative throughput only
-
Modem (110) is an outdated signaling rate while SCSI (LVD Ultra160) is a high-speed storage standard
-
Precision is limited when comparing such disparate data rates
-
Contextual knowledge is required to properly understand conversion results
Frequently Asked Questions
-
What does modem (110) represent?
-
Modem (110) denotes a legacy modem transmission speed of about 110 bits per second, used in early dial-up and teletype communications.
-
What is SCSI (LVD Ultra160)?
-
SCSI (LVD Ultra160) is a parallel SCSI interface using Low Voltage Differential signaling with bandwidth up to 160 megabytes per second, common in storage device interfaces.
-
Why convert between modem (110) and SCSI (LVD Ultra160)?
-
Converting these units allows comparison of very low legacy serial data rates against modern storage interface bandwidths, aiding in vintage computing analysis and system compatibility assessments.
Key Terminology
-
modem (110)
-
A legacy modem transmission speed of approximately 110 bits per second used in early dial-up and teletype communication systems.
-
SCSI (LVD Ultra160)
-
A parallel SCSI interface standard using Low Voltage Differential signaling with a bandwidth specification of up to 160 megabytes per second.
-
Low Voltage Differential (LVD)
-
A signaling method used in SCSI interfaces to achieve high-speed and noise-immune data transmission.