What Is This Tool?
This tool converts data transfer speeds from modem (110), an early dial-up bit rate unit, into SCSI (Async), which represents asynchronous Small Computer System Interface transfer rates. It's useful for comparing legacy communication speeds with asynchronous SCSI device performance.
How to Use This Tool?
-
Enter the data transfer value in modem (110) units.
-
Select modem (110) as the input unit and SCSI (Async) as the output unit.
-
Click convert to see the equivalent rate in SCSI (Async) units.
Key Features
-
Converts between modem (110) and SCSI (Async) units precisely as defined.
-
Browser-based and easy to use with simple input and output fields.
-
Supports conversion for legacy data transfer rates relevant to vintage and embedded systems.
Examples
-
110 modem (110) converts to approximately 0.0010083 SCSI (Async).
-
1000 modem (110) converts to approximately 0.0091667 SCSI (Async).
Common Use Cases
-
Comparing speeds of old dial-up and teletype communication devices to asynchronous SCSI data rates.
-
Benchmarking and troubleshooting legacy SCSI devices operating in asynchronous mode.
-
Testing and documenting vintage hardware or embedded system communication protocols.
Tips & Best Practices
-
Use this converter primarily for historical or compatibility reference rather than precise performance measures.
-
Consider the nominal nature of the conversion factor due to differences in communication technologies.
-
Verify SCSI device configurations independently when troubleshooting timing or handshake issues.
Limitations
-
The conversion provides a nominal approximation and does not represent actual data throughput accurately.
-
Modem (110) rates are much lower and mostly serve as legacy reference points compared to typical SCSI speeds.
Frequently Asked Questions
-
What does modem (110) represent in data transfer rates?
-
Modem (110) denotes an early modem transmission speed of about 110 bits per second used in historical dial-up and teletype communications.
-
How is SCSI (Async) different from synchronous SCSI modes?
-
SCSI (Async) transfers data using request/acknowledge handshakes without a shared clock, so throughput depends on device response and bus arbitration.
-
Why should I use this conversion tool?
-
It's useful for comparing legacy modem speeds with asynchronous SCSI device rates, helping in vintage computing, embedded systems development, and performance testing.
Key Terminology
-
modem (110)
-
A legacy data transfer unit representing a modem speed of about 110 bits per second used in early dial-up communication.
-
SCSI (Async)
-
An asynchronous data transfer mode in SCSI devices where data is exchanged by request and acknowledge handshakes without a shared clock.
-
Data transfer rate
-
The speed at which data is transmitted from one device to another, typically measured in bits per second.