What Is This Tool?
This tool facilitates converting data transfer rates from SCSI (Async), which uses asynchronous communication in storage devices, to T2 (signal), a legacy telecommunications carrier standard. It helps users compare and integrate performance metrics between older computer storage and telecom infrastructures.
How to Use This Tool?
-
Enter the data transfer value measured in SCSI (Async) units
-
Choose SCSI (Async) as the source unit and T2 (signal) as the target unit
-
Click convert to see the equivalent data rate expressed in T2 (signal)
-
Use the result to compare legacy device throughput with telecommunications carriers
Key Features
-
Converts data rates from SCSI (Async) to T2 (signal) accurately using defined conversion rate
-
Supports benchmarking and troubleshooting of legacy hardware involving asynchronous data transfers
-
Enables analysis of historical telecommunications and computing system integration
-
Browser-based and easy to use with straightforward input and output
Examples
-
5 SCSI (Async) translates to 9.505703422 T2 (signal)
-
0.5 SCSI (Async) converts to 0.9505703422 T2 (signal)
-
Use these for benchmarking asynchronous SCSI device speeds against T2 telecom lines
Common Use Cases
-
Benchmarking throughput of legacy SCSI devices running asynchronously
-
Troubleshooting handshake and timing issues on SCSI buses
-
Configuring retrocomputing environments with asynchronous SCSI hardware
-
Comparing legacy storage transfer rates with T-carrier telecommunications lines
-
Assessing medium-capacity leased line performance in historic telecom contexts
Tips & Best Practices
-
Verify device response times when using SCSI (Async) data for conversions
-
Consider the nominal rate and potential overhead in T2 signal measurements
-
Use conversions primarily for retrocomputing, legacy benchmarking, or telecom history analyses
-
Cross-check results when applying conversions for system integration projects
Limitations
-
Accuracy depends on specific timing variations of asynchronous SCSI devices
-
T2 (signal) nominal rates may vary due to line conditions and multiplexing
-
Both unit standards are outdated, limiting relevance for modern high-speed transfers
Frequently Asked Questions
-
What does SCSI (Async) represent?
-
SCSI (Async) indicates an asynchronous data transfer mode in the SCSI protocol using request/acknowledge handshakes instead of a shared clock.
-
What is T2 (signal) used for?
-
T2 (signal) is a legacy North American digital carrier transmitting data at about 6.312 Mbps for medium-capacity leased lines and telecom trunking.
-
Why convert from SCSI (Async) to T2 (signal)?
-
Conversion helps compare legacy asynchronous SCSI device transfer rates with historical T-carrier telecom lines for system integration or performance benchmarking.
Key Terminology
-
SCSI (Async)
-
The asynchronous data transfer mode of the SCSI protocol, where data exchanges happen through request/acknowledge handshakes without a shared clock.
-
T2 (signal)
-
A historic North American digital carrier line transmitting approximately 6.312 Mbps by multiplexing multiple PCM channels into a single communications trunk.