What Is This Tool?
This tool enables conversion between data transfer units used by legacy storage protocols, specifically from IDE (PIO mode 3) to SCSI (Async). It helps users compare and analyze the performance characteristics of these different storage interface modes.
How to Use This Tool?
-
Enter the value you want to convert in IDE (PIO mode 3) units.
-
Select SCSI (Async) as the target data transfer unit.
-
Click convert to see the equivalent SCSI (Async) data transfer rate.
Key Features
-
Converts data transfer rates from IDE (PIO mode 3) to SCSI (Async).
-
Supports legacy computing and embedded system use cases.
-
Browser-based and easy to operate without additional software.
Examples
-
2 IDE (PIO mode 3) equals 14.8 SCSI (Async).
-
5 IDE (PIO mode 3) equals 37 SCSI (Async).
Common Use Cases
-
Comparing data transfer rates between legacy IDE devices and asynchronous SCSI devices.
-
Diagnosing timing and handshake issues in SCSI bus communications.
-
Configuring embedded or retrocomputing systems using these transfer modes.
Tips & Best Practices
-
Use this conversion to assist with performance benchmarking in legacy systems.
-
Always consider device-specific protocol behavior when analyzing results.
-
Apply conversions carefully to aid troubleshooting and configuration decisions.
Limitations
-
Conversion is approximate; actual throughput depends on device response and arbitration.
-
Protocol overhead and environmental factors may significantly affect real-world performance.
-
Theoretical maximums do not guarantee identical practical data transfer speeds.
Frequently Asked Questions
-
What is IDE (PIO mode 3)?
-
IDE (PIO mode 3) is a programmed I/O transfer mode for Parallel ATA/IDE devices, driven by the CPU without DMA, with a theoretical throughput around 11.1 MB/s.
-
How does SCSI (Async) differ from synchronous modes?
-
SCSI (Async) transfers data asynchronously via request/acknowledge handshakes without a shared clock, making throughput dependent on device response time and bus arbitration.
-
Why convert between IDE (PIO mode 3) and SCSI (Async)?
-
Conversion helps compare legacy device performance, troubleshoot compatibility issues, and assist in configuring older or embedded computing systems.
Key Terminology
-
IDE (PIO mode 3)
-
A CPU-controlled programmed I/O transfer mode for Parallel ATA/IDE devices with a maximum theoretical throughput near 11.1 MB/s.
-
SCSI (Async)
-
An asynchronous data transfer mode in the SCSI protocol using request/acknowledge handshakes, with throughput depending on device timing and bus control.