What Is This Tool?
This unit converter transforms data transfer values from SCSI (Async), an asynchronous SCSI protocol mode, to IDE (UDMA mode 0), a Parallel ATA Ultra DMA transfer mode. It helps analyze, compare, and troubleshoot legacy storage device transfer rates.
How to Use This Tool?
-
Enter the data transfer rate value in SCSI (Async) units
-
Select SCSI (Async) as the input unit and IDE (UDMA mode 0) as the output unit
-
Click convert to see the corresponding transfer rate in IDE (UDMA mode 0)
Key Features
-
Accurate conversion from SCSI (Async) to IDE (UDMA mode 0) based on the specific conversion rate
-
Supports comparison of transfer rates for legacy SCSI and PATA/IDE devices
-
Ideal for performance analysis and troubleshooting of older hardware interfaces
-
Browser-based and easy to use with no installation required
Examples
-
10 SCSI (Async) equals approximately 0.9036 IDE (UDMA mode 0)
-
100 SCSI (Async) converts to about 9.0361 IDE (UDMA mode 0)
Common Use Cases
-
Benchmarking throughput of legacy SCSI devices running in asynchronous mode
-
Troubleshooting SCSI bus timing and compatibility between initiator and target devices
-
Configuring and testing embedded or retrocomputing systems with asynchronous SCSI connections
-
Specifying and diagnosing data transfer performance on PATA/IDE drives using Ultra DMA mode 0
-
Resolving BIOS or driver DMA timing issues to improve system compatibility
-
Comparing old PATA interface limits when planning migration to newer interfaces like SATA or USB
Tips & Best Practices
-
Use this converter primarily for legacy hardware performance comparisons and diagnostics
-
Remember the conversion reflects nominal rates; actual transfer speeds may vary due to hardware conditions
-
Cross-check transfer values if precise benchmarking or system tuning is required
-
Combine conversion results with device-specific documentation and diagnostics for best outcomes
Limitations
-
The conversion is approximate because SCSI (Async) throughput varies with device response and bus arbitration, while IDE (UDMA mode 0) defines a nominal maximum raw rate
-
Real-world performance may differ and is not directly equivalent despite the calculated conversion
-
This tool does not account for synchronous SCSI modes or faster PATA modes beyond UDMA mode 0
Frequently Asked Questions
-
What does SCSI (Async) mean in terms of data transfer?
-
SCSI (Async) refers to the asynchronous transfer mode of SCSI devices, where data transfers use request/acknowledge handshakes instead of a shared clock, making throughput dependent on device response and arbitration.
-
Why convert from SCSI (Async) to IDE (UDMA mode 0)?
-
Users convert between these units to compare data transfer rates of legacy devices for performance analysis, troubleshooting, or planning migrations between SCSI and PATA/IDE interfaces.
-
Is the conversion between SCSI (Async) and IDE (UDMA mode 0) exact?
-
No. The conversion is approximate because SCSI (Async) throughput varies and IDE (UDMA mode 0) defines a nominal rate, so real-world speeds can differ.
Key Terminology
-
SCSI (Async)
-
The asynchronous data transfer mode of the SCSI protocol using request/acknowledge handshakes without a shared clock, affecting throughput by device response times and bus arbitration.
-
IDE (UDMA mode 0)
-
An Ultra DMA transfer mode for Parallel ATA devices, defining interface timing and a nominal maximum raw data rate near 16.7 MB/s for DMA transfers.
-
Data Transfer Rate
-
The speed at which data is transmitted from one device to another, measured here in units relevant to legacy storage interfaces.