What Is This Tool?
This converter enables you to convert data transfer rates from IDE (UDMA-66) to IDE (UDMA mode 0), two legacy Parallel ATA transfer modes. It helps users compare performance and configure legacy PATA devices.
How to Use This Tool?
-
Enter the data transfer value in IDE (UDMA-66) mode
-
Select IDE (UDMA mode 0) as the target unit
-
Initiate the conversion to see the equivalent value
-
Use the results to assess performance or hardware compatibility
Key Features
-
Supports conversion between IDE (UDMA-66) and IDE (UDMA mode 0) data transfer rates
-
Provides theoretical maximum transfer rate conversions for legacy IDE interfaces
-
Simple interface to input values and get conversions instantly
-
Useful for diagnostics, benchmarking, and hardware configuration of PATA devices
Examples
-
Converting 2 IDE (UDMA-66) results in approximately 7.95 IDE (UDMA mode 0)
-
Converting 0.5 IDE (UDMA-66) results in around 1.99 IDE (UDMA mode 0)
Common Use Cases
-
Verifying maximum burst throughput of older PATA hard drives
-
Selecting or troubleshooting drive transfer modes in BIOS for compatibility
-
Diagnosing transfer speeds or errors on legacy IDE systems
-
Comparing legacy PATA limits when upgrading to newer interfaces like SATA or USB
Tips & Best Practices
-
Always verify device and controller support for the target transfer mode
-
Use the conversion to assist in troubleshooting or benchmarking legacy hardware
-
Recognize that actual speeds may be affected by cable quality and device conditions
-
Apply conversions mainly for legacy systems, as modern drives use newer interfaces
Limitations
-
Conversion is based on theoretical maximum data transfer rates only
-
Does not account for real-world overhead or device-specific performance differences
-
Applies solely to legacy PATA/IDE interfaces, not modern standards like SATA or NVMe
Frequently Asked Questions
-
What does IDE (UDMA-66) mean?
-
IDE (UDMA-66), also known as Ultra DMA Mode 4 or ATA‑66, is a Parallel ATA transfer mode defining a maximum raw data rate of 66.7 megabytes per second, using an 80-conductor PATA cable.
-
Why convert IDE (UDMA-66) to IDE (UDMA mode 0)?
-
Conversion helps understand and compare transfer speeds between legacy PATA modes, which is useful for diagnosing performance or configuring older hardware.
-
Can this converter be used for modern SATA drives?
-
No, this tool is designed exclusively for legacy PATA/IDE interfaces and does not apply to SATA or NVMe devices.
Key Terminology
-
IDE (UDMA-66)
-
A Parallel ATA transfer mode with a max theoretical data rate of 66.7 MB/s, requiring an 80-conductor PATA cable.
-
IDE (UDMA mode 0)
-
Ultra DMA transfer mode 0 for PATA devices, defining interface timing with a max nominal data rate of about 16.7 MB/s.
-
PATA (Parallel ATA)
-
Legacy interface standard for connecting storage devices, preceded SATA and NVMe technologies.