What Is This Tool?
This converter allows users to transform data transfer values from Virtual Tributary 2 (signal), a telecom payload format, into SCSI (Fast Ultra Wide), a legacy parallel storage interface standard. It helps bridge understanding between telecom signal rates and storage interface data throughput.
How to Use This Tool?
-
Enter the amount of Virtual Tributary 2 (signal) units you want to convert.
-
Select SCSI (Fast Ultra Wide) as the target unit for conversion.
-
Initiate the conversion process to receive the equivalent data transfer value.
-
Use the result to analyze or compare telecom and storage interface throughput.
Key Features
-
Converts data transfer values between Virtual Tributary 2 (VT2) signals and SCSI (Fast Ultra Wide) units.
-
Based on defined conversion rate of 1 VT2 equals 0.0072 SCSI (Fast Ultra Wide).
-
Supports telecom and legacy storage interface data rate comparisons.
-
Browser-based and easy-to-use unit conversion tool.
Examples
-
10 Virtual Tributary 2 (signal) = 0.072 SCSI (Fast Ultra Wide)
-
50 Virtual Tributary 2 (signal) = 0.36 SCSI (Fast Ultra Wide)
Common Use Cases
-
Transporting E1 circuits over SONET backbones using Virtual Tributary 2 signals.
-
Configuring telecommunications equipment for grooming lower-rate PDH channels.
-
Connecting internal hard drives or RAID controllers via legacy parallel SCSI interfaces.
-
Planning capacity in telecom networks and legacy enterprise storage setups.
-
Understanding interoperability between telecom payloads and storage data rates.
Tips & Best Practices
-
Use the conversion for estimating equivalent data transfer levels rather than precise real-world throughput.
-
Consider protocol overhead and signaling differences when applying results in engineering contexts.
-
Use this tool for planning and comparison, especially when interfacing telecom signals with legacy storage systems.
-
Verify specific device capabilities separately due to variations in real sustained data rates.
Limitations
-
Conversion is based on nominal or maximum throughput values, not continuous sustained rates.
-
SCSI (Fast Ultra Wide) describes an interface capability rather than a pure physical unit, limiting direct comparison.
-
Differences in error correction, protocol overhead, and signaling mean results are approximate.
-
Real-world performance may vary from the conversion output due to technical constraints.
Frequently Asked Questions
-
What does Virtual Tributary 2 (signal) represent?
-
Virtual Tributary 2 (VT2) is a SONET/SDH sub-rate signal format carrying a 2.048 Mbps payload, typically representing an E1 channel within higher-rate SONET/SDH frames.
-
What is SCSI (Fast Ultra Wide)?
-
SCSI (Fast Ultra Wide) is a legacy parallel Small Computer System Interface standard that uses a wider data bus and faster signaling to offer higher data transfer capabilities compared to earlier narrow SCSI modes.
-
Why convert between these two units?
-
Converting between Virtual Tributary 2 and SCSI (Fast Ultra Wide) helps compare telecom data rates with legacy storage interface throughput for system design and compatibility considerations.
Key Terminology
-
Virtual Tributary 2 (VT2)
-
A SONET/SDH sub-rate signal format carrying a 2.048 Mbps payload inside higher-rate SONET/SDH frames, enabling multiplexing of E1 channels.
-
SCSI (Fast Ultra Wide)
-
A legacy parallel Small Computer System Interface mode combining wider data bus and faster signaling to enhance sustained throughput in storage device connections.
-
E1 Channel
-
A 2.048 Mbps digital transmission channel used primarily in telecommunications as a standard data payload carried within Virtual Tributary 2 signals.