What Is This Tool?
This converter allows you to translate data transfer rates from ISDN (dual channel), a telecommunication service-level descriptor for combined B channels, to STM-16 (signal), a high-capacity Synchronous Digital Hierarchy optical or electrical line rate. It's especially useful for comparing small-scale ISDN rates with large-scale optical trunk rates.
How to Use This Tool?
-
Enter the value in ISDN (dual channel) representing combined 64 kbit/s channels
-
Select ISDN (dual channel) as the input unit and STM-16 (signal) as the output
-
Click convert to obtain the equivalent STM-16 (signal) line rate
-
Use the result to plan network capacity or integrate legacy ISDN links
Key Features
-
Converts ISDN (dual channel) data rates to STM-16 (signal) line rates
-
Based on standardized telecommunication definitions within the ISDN and SDH frameworks
-
Shows examples for practical understanding
-
Browser-based and easy to use for network engineers and telecom professionals
Examples
-
10 ISDN (dual channel) converts to approximately 0.000514403 STM-16 (signal)
-
100 ISDN (dual channel) is equivalent to about 0.00514403 STM-16 (signal)
Common Use Cases
-
Small-office or home internet access combining two B channels for around 128 kbit/s
-
Remote LAN access or backup links using bonded ISDN channels
-
Voice and data scenarios where bonding B channels enhances throughput
-
Telecom carrier networks aggregating multiple ISDN channels into SDH systems
-
Designing or managing carrier optical backbone links and inter-office connections
Tips & Best Practices
-
Use this converter to relate ISDN data rates to large SDH line rates for network planning
-
Consider the scale difference when comparing these units, since ISDN is low-rate and STM-16 is high-capacity
-
Verify channel bonding assumptions when applying conversions in practice
-
Remember this tool represents a scale comparison rather than exact unit equivalence
Limitations
-
ISDN (dual channel) is not an SI unit but a bandwidth descriptor at around 128 kbit/s
-
STM-16 (signal) represents a standardized line rate in the Gbit/s range, so units differ fundamentally
-
Conversion assumes perfect channel bonding and does not factor in protocol overhead or physical signal constraints
-
The result reflects scale comparison, not a direct physical equivalence
Frequently Asked Questions
-
What does ISDN (dual channel) represent?
-
ISDN (dual channel) refers to using both 64 kbit/s B channels of an ISDN Basic Rate Interface in parallel to provide about 128 kbit/s combined data throughput.
-
What is STM-16 (signal)?
-
STM-16 (signal) is an SDH line rate with a gross bit rate of 2.48832 Gbit/s used in carrier networks for multiplexing digital channels over optical or electrical links.
-
Why convert from ISDN (dual channel) to STM-16 (signal)?
-
Conversion helps network engineers relate small-scale ISDN data rates to large-scale SDH line rates for planning network capacity or integrating legacy ISDN lines into modern carrier backbones.
-
Is the conversion a direct unit equivalence?
-
No, the conversion is a scale comparison between a low-rate data descriptor and a high-capacity SDH line rate, not a strict unit equivalence.
Key Terminology
-
ISDN (dual channel)
-
A telecommunication data rate descriptor using both 64 kbit/s B channels bonded to provide about 128 kbit/s throughput.
-
STM-16 (signal)
-
A standardized SDH line rate at 2.48832 Gbit/s used to carry multiplexed digital channels over optical or electrical links.
-
Channel Bonding
-
The technique of combining two or more channels in parallel to increase total data throughput.
-
Synchronous Digital Hierarchy (SDH)
-
A standardized protocol for high-speed digital transmission used in telecommunications networks.