What Is This Tool?
This converter helps translate data transfer values from Virtual Tributary 2 (payload), a container for 2.048 Mb/s PDH/E1 channels, into Virtual Tributary 1 (payload), a sub-rate container suited for DS1/T1 signals. It supports managing legacy TDM circuit transport within SONET/SDH synchronous optical networks.
How to Use This Tool?
-
Enter the value in Virtual Tributary 2 (payload) you wish to convert.
-
Select Virtual Tributary 2 (payload) as the source unit and Virtual Tributary 1 (payload) as the target unit.
-
Click convert to obtain the equivalent VT1 payload value according to the established conversion rate.
Key Features
-
Converts VT2 payloads carrying E1 channels to VT1 payloads suitable for DS1/T1 mapping.
-
Facilitates multiplexing and grooming of low-rate signals within high-capacity SONET/SDH frames.
-
Supports translation needed for carrier networks to interwork PDH and SONET/SDH equipment.
Examples
-
1 Virtual Tributary 2 (payload) equals approximately 1.326 Virtual Tributary 1 (payload).
-
5 Virtual Tributary 2 (payload) converts to about 6.632 Virtual Tributary 1 (payload).
Common Use Cases
-
Transporting E1 data streams over SONET/SDH optical rings via VT1.5 mapping.
-
Grooming multiple low-rate customer circuits into a single high-rate SONET/SDH payload.
-
Converting legacy PDH channels into SONET transport containers for better bandwidth management.
Tips & Best Practices
-
Ensure correct unit selection before conversion to avoid errors.
-
Verify timing and alignment to maintain signal quality after conversion.
-
Use this conversion for SONET/SDH virtual tributary payloads only, respecting equipment constraints.
Limitations
-
Applies strictly to SONET/SDH virtual tributary payload conversions and not to proprietary or non-standard frames.
-
Requires precise timing and alignment for signal integrity during transport.
-
Equipment and network constraints may affect direct substitution without proper mapping frameworks.
Frequently Asked Questions
-
What does converting from VT2 to VT1 payload achieve?
-
It translates E1-based PDH channels into DS1/T1-based SONET frames, allowing legacy signals to be groomed and transported within synchronous optical networks.
Key Terminology
-
Virtual Tributary 2 (payload)
-
A SONET/SDH virtual tributary container sized for 2.048 Mb/s PDH/E1 channels used to transport low-rate TDM signals.
-
Virtual Tributary 1 (payload)
-
A sub-rate container in SONET/SDH for carrying lower-bit-rate signals like DS1/T1 channels multiplexed into higher-rate frames.
-
SONET/SDH
-
Synchronous Optical Networking technologies providing standardized optical transport frameworks for high-capacity data streams.