What Is This Tool?
This unit converter allows you to translate data transfer rates expressed in gigabit per second (SI definition) into equivalent speeds using the SCSI (Fast Ultra Wide) interface standard, which is a legacy parallel data transfer mode used primarily in older storage systems.
How to Use This Tool?
-
Enter the data transfer value expressed in gigabit per second (SI def.)
-
Select the output unit as SCSI (Fast Ultra Wide)
-
Review the converted output which reflects equivalent legacy SCSI speed
-
Use the result to assess or compare legacy SCSI storage interface speeds with modern data rates
Key Features
-
Converts between modern gigabit/second (SI def.) rates and legacy SCSI (Fast Ultra Wide) speeds
-
Based on an established conversion factor linking gigabit per second to SCSI (Fast Ultra Wide)
-
Supports data transfer unit conversion relevant to networking and storage hardware
-
Browser-based and easy to use for quick data transfer rate comparisons
Examples
-
Converting 2 gigabit/second (SI def.) gives 6.25 SCSI (Fast Ultra Wide)
-
Converting 0.5 gigabit/second (SI def.) results in 1.5625 SCSI (Fast Ultra Wide)
Common Use Cases
-
Evaluating local area network speeds relative to legacy SCSI storage interfaces
-
Planning and integrating older servers and workstations that use parallel SCSI connections
-
Comparing modern data transfer rates to legacy backup systems and tape libraries using SCSI
-
Mapping new network bandwidth measurements to legacy SCSI storage hardware for IT management
Tips & Best Practices
-
Always verify hardware compatibility when referencing legacy SCSI speed equivalents
-
Use the converter for performance estimation rather than exact throughput predictions
-
Consider potential overhead and protocol differences when comparing data transfer rates
-
Apply conversions primarily in contexts involving legacy SCSI storage and network interface planning
Limitations
-
SCSI (Fast Ultra Wide) is a legacy interface and not a formal SI unit
-
Actual performance can vary due to physical hardware, cable length, and system overhead
-
Conversion does not factor in protocol overhead, error correction, or real-world transfer inefficiencies
-
The equivalence is approximate and may not reflect true throughput in practical deployments
Frequently Asked Questions
-
What does gigabit per second (SI def.) represent?
-
It represents a data transfer rate of one billion bits per second, commonly used in networking to express link capacity.
-
Is SCSI (Fast Ultra Wide) a standard SI unit?
-
No, SCSI (Fast Ultra Wide) is a legacy interface standard describing parallel data transfer modes rather than an SI unit.
-
Why convert from gigabit/second to SCSI (Fast Ultra Wide)?
-
This conversion helps compare or translate modern network transfer rates into legacy storage interface speeds for integration or performance assessment.
Key Terminology
-
Gigabit per second (SI def.)
-
A data rate of 10^9 bits per second used mainly in network link capacity and throughput measurements.
-
SCSI (Fast Ultra Wide)
-
A legacy parallel Small Computer System Interface mode with a 16-bit wide bus designed for higher throughput in storage device connectivity.
-
Data Transfer Rate
-
The speed at which data is transmitted or processed over a communication channel per unit time.