What Is This Tool?
This converter transforms data transfer rates from IDE (DMA mode 2), a legacy parallel ATA transfer mode, into equivalent STS1 (signal) rates, the fundamental unit in synchronous optical networking. It helps bridge legacy storage transfer metrics with telecom-grade optical transmission standards.
How to Use This Tool?
-
Enter the data transfer value in IDE (DMA mode 2) units.
-
Choose IDE (DMA mode 2) as the source unit and STS1 (signal) as the target unit.
-
Click the convert button to see the equivalent STS1 (signal) value.
-
Use results to compare or integrate legacy disk transfer rates with synchronous optical network standards.
Key Features
-
Convert data transfer rates between IDE (DMA mode 2) and STS1 (signal).
-
Supports legacy parallel ATA and SONET optical networking standards.
-
Includes pre-defined conversion rate based on standardized definitions.
-
Useful for IT diagnostics, telecom provisioning, and legacy system benchmarking.
-
Browser-based and easy to use without software installation.
Examples
-
1 IDE (DMA mode 2) equals 2.5617283951 STS1 (signal).
-
3 IDE (DMA mode 2) equals 7.6851851853 STS1 (signal).
Common Use Cases
-
Configuring or diagnosing legacy PATA/IDE drives to ensure correct DMA mode usage.
-
Evaluating data transfer throughput equivalences between legacy IDE storage and SONET optical links.
-
Provisioning telecom circuits using SONET standards while comparing legacy data interfaces.
-
Benchmarking legacy storage devices against modern networking transport rates.
Tips & Best Practices
-
Ensure the input value represents transfer rates using IDE DMA mode 2 accurately.
-
Understand that STS1 values include SONET overhead affecting direct throughput comparison.
-
Use this conversion for benchmarking and diagnostics rather than precise performance metrics.
-
Cross-check results with actual system capabilities when integrating legacy and modern networks.
Limitations
-
IDE (DMA mode 2) is a legacy interface with lower maximum throughput than STS1.
-
STS1 includes protocol overhead, so throughput equivalence may differ in practice.
-
The conversion assumes ideal conditions, excluding hardware bottlenecks or inefficiencies.
Frequently Asked Questions
-
What is IDE (DMA mode 2)?
-
IDE (DMA mode 2) is a legacy Parallel ATA data transfer mode that moves data directly to or from system memory with minimal CPU involvement.
-
What does STS1 (signal) represent?
-
STS1 (signal) is the basic SONET electrical and framing unit carrying a line rate of 51.84 megabits per second, used in synchronous optical networking.
-
Why convert from IDE (DMA mode 2) to STS1 (signal)?
-
This conversion helps compare or integrate legacy disk transfer rates with modern synchronous optical network protocols for diagnostics or benchmarking.
Key Terminology
-
IDE (DMA mode 2)
-
A legacy Parallel ATA data-transfer mode that enables direct memory access to improve transfer rates with less CPU overhead.
-
STS1 (signal)
-
The basic unit of the SONET synchronous optical networking system, carrying a line rate of 51.84 megabits per second including overhead.
-
SONET
-
Synchronous Optical Network, a standardized protocol for optical telecommunications transport.