What Is This Tool?
This tool converts data transfer speeds from IDE (DMA mode 1), a legacy IDE/ATA interface mode, to SCSI (Fast Wide), a SCSI-2 interface mode that supports faster data throughput. It helps users compare and integrate data rates between different legacy storage technologies.
How to Use This Tool?
-
Enter the value in IDE (DMA mode 1) units you want to convert.
-
Select IDE (DMA mode 1) as the source unit and SCSI (Fast Wide) as the target unit.
-
Click the convert button to see the equivalent SCSI (Fast Wide) value.
-
Use the conversion results to analyze or configure legacy hardware settings.
Key Features
-
Converts data transfer values from IDE (DMA mode 1) to SCSI (Fast Wide).
-
Uses a defined conversion rate and formula for accuracy based on legacy hardware specs.
-
Supports performance comparisons in environments with mixed storage interfaces.
-
Browser-based and easy to use without software installation.
Examples
-
2 IDE (DMA mode 1) equals 1.33 SCSI (Fast Wide).
-
5 IDE (DMA mode 1) equals 3.325 SCSI (Fast Wide).
Common Use Cases
-
Comparing data transfer rates between older IDE hard drives and faster SCSI interfaces.
-
Tuning legacy system performance when IDE and SCSI devices coexist.
-
Configuring BIOS or OS settings for device compatibility in mixed storage environments.
-
Supporting legacy RAID setup and archival storage management.
Tips & Best Practices
-
Verify device compatibility and protocol support before applying conversion results.
-
Consider hardware factors like cable quality and signaling type when interpreting data rates.
-
Use conversion results as guidelines to improve hardware performance and troubleshooting.
-
Keep legacy system configurations documented for future reference.
Limitations
-
Conversion rates are theoretical and depend on hardware implementations and physical characteristics.
-
IDE (DMA mode 1) and SCSI (Fast Wide) use different protocols and architectures, limiting direct equivalency.
-
Real throughput may vary due to signal integrity, device negotiation, and cable types.
Frequently Asked Questions
-
What does IDE (DMA mode 1) mean?
-
IDE (DMA mode 1) is a data transfer mode defined for IDE/ATA devices allowing direct memory access with moderate speed under the ATA specification.
-
What is SCSI (Fast Wide)?
-
SCSI (Fast Wide) is a SCSI-2 interface mode using a 16-bit bus and 10 MHz signaling to provide higher data transfer rates than original 8-bit SCSI.
-
Why convert between IDE (DMA mode 1) and SCSI (Fast Wide)?
-
Converting between these units helps compare and integrate data rates in legacy systems with mixed storage interfaces for performance tuning and compatibility.
Key Terminology
-
IDE (DMA mode 1)
-
A Direct Memory Access transfer mode for IDE/ATA devices enabling moderate-speed data transfers while reducing CPU load.
-
SCSI (Fast Wide)
-
A SCSI-2 interface mode combining Fast timing and a wide 16-bit data bus for improved transfer rates.
-
Data Transfer Rate
-
The speed at which data is moved from one device or interface to another, often measured in megabytes per second.