What Is This Tool?
This converter allows you to translate flow measurements from pound per day for gasoline at a standardized temperature of 15.5 °C, a mass flow rate unit commonly used in the petroleum sector, into cubic inches per hour, a volumetric flow unit suited for very low flow volumes.
How to Use This Tool?
-
Enter the mass flow value in pound/day for gasoline at 15.5 °C
-
Select the source unit 'pound/day (Gasoline at 15.5°C)'
-
Choose the target unit 'cubic inch/hour [in³/h]'
-
Click convert to see the equivalent volumetric flow rate
-
Use the result for inventory control, instrumentation, or leak rate analysis
Key Features
-
Converts gasoline mass flow standardized at 15.5 °C to volumetric flow units
-
Supports applications in fuel processing, leak detection, and low-flow calibration
-
Provides straightforward conversion using standardized unit definitions
-
Browser-based tool requiring no installation
-
Applicable for custody transfer, inventory, and emission reporting
Examples
-
5 pound/day (Gasoline at 15.5°C) converts to approximately 7.8 cubic inch/hour
-
10 pound/day (Gasoline at 15.5°C) converts to about 15.6 cubic inch/hour
Common Use Cases
-
Custody transfer and inventory accounting at gasoline terminals and pipelines
-
Refinery throughput analysis and mass-balance calculations for gasoline operations
-
Fuel consumption and emissions reporting based on standardized gasoline mass
-
Leak rate measurement in sealed systems such as vacuum or refrigerant chambers
-
Low-flow dosing and precise delivery in laboratory or microfluidic applications
-
Calibration of very-low-flow pumps, meters, and drip-feed devices
Tips & Best Practices
-
Ensure gasoline quantities are referenced to the standard 15.5 °C temperature
-
Use the converter for applications involving low volumetric flow rates
-
Verify gasoline composition to confirm applicability of the standard density assumption
-
Apply this tool for mass-to-volume conversions where instrumentation requires volumetric units
-
Supplement conversion results with measurement context for inventory or quality control
Limitations
-
Conversion depends on gasoline density standardized at 15.5 °C; temperature changes may affect accuracy
-
Cubic inch/hour unit is intended for measuring very low volumetric flow and may be impractical for large volumes
-
Mass-to-volume conversions require precise density data referenced to the specified temperature
-
The tool does not adjust for gasoline composition variations affecting density
Frequently Asked Questions
-
Why is gasoline standardized at 15.5 °C for this unit?
-
Gasoline quantities are referenced to 15.5 °C to maintain consistent density and enable accurate mass and volumetric flow comparisons in industrial measurements.
-
Can this tool convert higher flow rates expressed in pound/day to cubic inch/hour?
-
While it can, cubic inch/hour is best suited for very low-volume flows, so it may not be practical for larger flow measurements.
-
Does the conversion account for variations in gasoline composition?
-
No, the conversion assumes a standard density based on gasoline at 15.5 °C and does not adjust for composition changes.
Key Terminology
-
Pound/day (Gasoline at 15.5°C)
-
A mass flow rate unit representing the pounds of gasoline moved or processed per day, standardized to a temperature of 15.5 °C.
-
Cubic inch/hour [in³/h]
-
A volumetric flow rate unit indicating the volume in cubic inches passing per hour, typically used for very low flow rates.
-
Standard Temperature (15.5 °C)
-
The reference temperature to which gasoline quantities are adjusted for accurate density and flow measurement.